If you’re an avid hunter chances are you’ve considered mounting a deer skull at some point. There’s something about having a trophy on your wall that just screams “I’m a badass.” But if you’ve never done it before the process can seem a bit daunting. Here’s a step-by-step guide on how to mount a European deer skull.
1. First you’ll need to remove the hide from the skull. This can be done with a sharp knife or a scalpel. Be careful not to cut yourself and work slowly to avoid damaging the skull.
2. Next remove the eyes and brain from the skull. This can be a messy step so be prepared with some gloves and a garbage bag.
3. Once the eyes and brain are removed you’ll need to degrease the skull. This can be done with a commercial degreasing solution or you can make your own by boiling the skull in water with some dish soap.
4. Once the skull is degreased you’ll need to whiten it. This is done to remove any remaining flesh and blood and to help the skull achieve a bright white color. There are a few different ways to whiten a skull but the most common is to bleaching it with hydrogen peroxide.
5. After the skull is whitened it’s time to mount it. This can be done with a European mount kit which can be purchased online or at most hunting stores. The kit will come with everything you need to mount the skull including instructions.
Following these steps will help you mount a European deer skull like a pro. So go out there and make your trophy wall dreams a reality!
What tools do you need to mount a european deer skull?
A saw a drill screws and washers.
What is the first step to mount a european deer skull?
Cut off the skull cap.
What is the second step to mount a european deer skull?
Clean the inside of the skull.
What is the third step to mount a european deer skull?
Drill holes in the skull.
What is the fourth step to mount a european deer skull?
Screw the skull to the mounting board.
What is the fifth step to mount a european deer skull?
Attach the washers.
What is the sixth step to mount a european deer skull?
Hang the mounted skull.
What is the seventh step to mount a european deer skull?
Enjoy your display!
How do you clean the inside of the skull?
With a hose wire brush and detergent.
How do you drill the holes in the skull?
With a drill and a 3/16″ drill bit.
How many holes do you drill in the skull?
Two holes.
How far apart should the holes be?
3 to 4 inches.
What kind of screws do you use?
3/16″ x 2″ screws.
How many washers do you use?
Four washers.
What is the best way to enjoy your mounted skull display?
With friends and family!
