How To Snake A Drain From Outside

Assuming you would like a blog post on the steps to take when snaking a drain from the outside:

“How to Snake a Drain from Outside


It is important to keep your drains clear and flowing smoothly to prevent any blockages from occurring. If a blockage does occur it is often best to try and clear it yourself before calling in a professional. Snaking a drain from the outside is one way to do this and is not as difficult as it may seem. With a few simple supplies you can have your drain unclogged and flowing again in no time.

What You Will Need:

-An auger or “plumber’s snake”

-Eye protection


-A bucket


1. Begin by locating the cleanout plug on your drain. This is typically located near the base of the drain pipe. The cleanout plug will be a round brass or plastic plug that can be unscrewed by hand.

2. Once the cleanout plug is removed you will be able to see the auger inside the drain pipe.

3. Feed the auger into the drain pipe until you feel resistance. This is likely the blockage that you are trying to clear.

4. Continue to feed the auger into the drain turning it as you go. You may need to use some force to get through the blockage.

5. Once the auger has broken through the blockage you can begin to withdraw it from the drain. As you do so the blockage should come with it.

6. If the blockage does not come out with the auger you may need to feed it a bit further into the drain and repeat steps 4 and 5.

See also  What Are Snakes

7. Once the blockage has been cleared replace the cleanout plug and flush the drain with hot water to clear any debris that may have been loosened during the snaking process.

If you are having persistent drain issues it is best to call in a professional. However for a one-time blockage snaking the drain from the outside is a relatively easy process that can be done without too much hassle.”

How do you snake a drain from outside?

Answer 1:

You will need a drain snake a garden hose and a wet/dry vac.

First attach the drain snake to the garden hose.

Next insert the drain snake into the drain and turn on the water.

The water will push the snake through the drain and clear the blockage.

Finally use the vac to remove any water that is left in the drain.

Leave a Comment